Hydraulic pool lifter B-2 150 kgs

General characteristics of the B-2 hydraulic pool lift:

• Approved to lift 150 kg.
• A water supply with a pressure of 3.5 bar is required for operation. To lift 150 kg, 5.5 bar is required.
• Rotation angle: 170º, clockwise (downwards).
• Turning radius 700 m/m.
• The operating control is located to the right of the user.
• The seat has a travel of 1.06 m and is adjustable in height, normally placed at +0.53 m and -0.53 m above the water level.
• It adapts to any pool because all the grips are adjustable.

Operational Data of the fixed hydraulic lift B-2:

• Net weight: 50 Kg
• Packed weight: 62 kg
• Climbing time empty: 20
• Climbing time with 85 kg load: 25"
• Lowering time empty: 42
• Lowering time with 85 kg load: 20"
• Water capacity in piston: 8 litres

Pre-installation and Installation:

The following points should be considered when choosing the location site:

• Easy accessibility for the user.
• It should not be in a place where other bathers pass through or park.
• The water intake should be as close as possible.
• We recommend placing the lift where the water depth is approximately 1.20/1.30 metres, so that if the user of the lift needs help, the person accompanying him/her can stand up safely.
• At the place where it has been decided to place the lift, a water supply of ½ inch and 3.5 bar must be provided. If the network does not have this pressure, a pressure group should be installed.

If the pool is already built, it is advisable to install the water inlet after the lift has been installed.

• Installation is very simple.
• It only has anchors on the outside of the pool.

Adjust the height of the seat and connect the hose to the water intake.